Start-Up - Astralpool 16631 Mode D'emploi

• The dosage of the product should follow Tables 1 and 2. The product
concentrations shown in the tables will never be exceeded.
• The appropriate measures should be taken to ensure that the equipment
is only operated in safe conditions. The equipment can be started up
once the degassing valve works.
• Check regularly whether there are any visible defects or anomalies which
may affect the safety of the equipment or the work area; if there are any,
notify the competent persons immediately. Turn off the pump which
supplies the equipment immediately if it affects the essential safety
requirements.
• Before starting up the equipment, make sure that there is nobody
exposed

5.2START-UP

• The purge valve will always be connected to the drain.
• After performing the assembly of the equipment, without having
introduced the load of trichloro compacts 34433, 34434, 34435, 34437 or
bromine tablets 16550 or 28740, proceed to check the sealing:
• Turn off the pump which supplies the equipment in the event of anomalies in
the operation and disconnect the power sources before handling it.
• Do not disable the degassing valve.
• Annual changeover of the degassing valve is recommended.
to a
1. Close the CLORIMAX lid
2. Close the purge valve
3. Start up the filtration equipment
4. Open the outlet and inlet valves, allowing the water
to circulate through the CLORIMAX.
5. After a few minutes, check that there is no leakage of
water in the installation.
6
possible leak therefrom.