Checchi & Magli UNIFOX Manuel D'utilisation Et D'entretien page 64

Arrangement of the seat and seedling holder
Poor work posture will tire the operator and could lead
to mistakes being made; therefore, before starting work,
C
UN41 0592GN
Proceed as outlined below.
1) Loosen the screws (A) and adjust the seat height.
2) Tighten the screws (A) to secure the seat in the right
position.
3) Loosen the nut (B) to move the seat lengthways in
relation to the vehicle.
Changing the dispenser chain
According to the plant spacing required, it may be nec-
essary to install a chain fitted with a different number of
grippers with respect to those already installed.
Carry out the operations described.
1) Loosen the nuts (A) to slacken off the chain.
2) Remove the joining link (B).
3) Remove the chain (C).
4) Fit the chain on the pinions along with the required
number of grippers.
5) Fit the joining link (B).
NOTICE
Fit the chain with the joining link positioned as
shown in the figure.
6) Tension the chain (see "Adjusting the dispenser chain
tension").
English language
INFORMATION FOR USE
adjust the seat and secure it in the position that offers
maximum comfort.
B
4) Tighten the nut (B) to secure the seat in the right po-
sition.
5) Loosen the screw (C).
6) Set the seedling container into the appropriate posi-
tion.
7) Tighten the screw (C).
B
C
UN41 0606GN
24
6
A
Use and maintenance