Checchi & Magli UNIFOX Manuel D'utilisation Et D'entretien page 63

A
UN41 0591GN
- For hitching, proceed as outlined below.
1) Position the work vehicle on flat, solid ground in a
risk-free area.
2) Start moving the tractor to move the three-point
hitch up to the lift frame.
3) Align the arms of the lifting unit with the coupling
points on the work vehicle.
4) Switch off the tractor engine, remove the ignition
key, and store in a safe place.
5) Turn the tie rods (A) to adjust the height of the lift
arms (B) (see tractor instruction manual).
6) Insert the pins (C) into the lift arms and fit in the lock
pins (D).
7) Turn the tie-rod (E) to adjust the space between the
tie-rod and the upper coupling (F) on the support
frame.
8) Insert the pin (G) and the lock pin (H).
9) Remove the safety lock pin (L), slide out pin (M), and
lift the resting foot (N) off the ground.
10) Adjust the tie-rod (E) so that the work vehicle is par-
allel with the ground.
English language
INFORMATION FOR USE
A
C
D
E
G
B
- For unhitching, proceed as outlined below.
1) Select an area with flat, solid ground to park the
work vehicle.
2) Using the tractor's controls, lower the work vehicle
to the ground.
3) Lower the resting foot (N), insert pin (M) and lock
pin (L).
4) Switch off the tractor engine, remove the ignition
key, and store in a safe place.
5) Take out the lock pin (H) and remove the pin (G).
6) Slide out the lock pins (D) and remove the lift arms
(B) from the work vehicle's coupling points.
23
H
M
F
Use and maintenance
6
L
N