Publicité
Les langues disponibles
Les langues disponibles
4.
Slip the accessory nozzle around the joint to be soldered. using the high temperature setting on the heat gun,
heat the joint.
5.
When the flux bubbles and the copper becomes slightly lighter in color, apply the solder wire to the perimeter
of the joint and reposition the heat gun so excess solder does not drip into it. Remove the heat gun when the
solder begins to evenly flow into and around the joint. Then wipe around the still hot joint with a damp rag to
remove excess solder and flux.
6.
If the joint's fitting is connecting more than one piece of pipe, all the pipe ends going into the common fitting
and fitting's internal surfaces should be properly prepared and connected together. Then all the joints should
be soldered in a single operation. (When soldering a new connection into a fitting already containing a finished
pipe joint, you risk melting the previously soldered joint and creating an eventual leak or failed joint.)
Soldering copper pipe fittings is commonly referred to as "sweating". The solder joins and seals the pipe to fitting
via capillary action which draws, or "sweats", the molten solder into the gap between the pipe and fitting surfaces,
creating a strong and leak free seal.
MaintenanCe
CLEANING
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. use clean cloths to remove dirt, dust, oil, grease, etc.
WarninG:
products, penetrating oils, etc., come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result in serious personal injury.
electric tools used on fiberglass material, wallboard, spackling compounds, or plaster are subject to accelerated
wear and possible premature failure because the fiberglass chips and groundings are highly abrasive to
bearings, brushes, commutators, etc. Consequently, we do not recommend using this tool for extended work on
these types of materials. However, if you do work with any of these materials, it is extremely important to clean
the tool using compressed air.
LUbRICATION
This tool is permanently lubricated at the factory and requires no additional lubrication.
tWO-Year WarrantY
This product is warranted free from defects in material and workmanship for 2 years after date of purchase. This
limited warranty does not cover normal wear and tear or damage from neglect or accident. The original purchaser
is covered by this warranty and it is not transferable. Prior to returning your tool to store location of purchase,
please call our Toll-Free Help Line for possible solutions.
THIS PRODUCT IS NOT WARRANTED IF USED FOR INDUSTRIAL OR COMMERCIAL PURPOSES.
ACCESSORIES INCLUDED IN THIS KIT ARE NOT COVERED BY THE 2 YEAR WARRANTY.
tOLL-free HeLp Line
For questions about this or any other GeNeSIS™ Product, please call Toll-Free:
www.genesispowertools.com
Or visit our web site:
©Richpower Industries, Inc. All Rights reserved
Richpower Industries, Inc.
736 Hampton Road
Williamston, SC 29697
Printed in China, on recycled pape4
Do not at any time let brake fluids, gasoline, petroleum-based
888-552-8665
.
11
Publicité
