Lubrication - Genesis GFDP160 Manuel D'utilisation

5. If drilling a through hole, make sure place a piece of backup material (wood, plywood, etc.) on the
table underneath the work piece to prevent splintering on the underside of the work piece.
MAinTEnAnCE
CLEANING
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from
various types of commercial solvents and may be damaged by their use. use clean cloths to remove
dirt, dust, oil, grease, etc.
WArning:
based products, penetrating oils, etc, come in contact with plastic parts.
Chemicals can damage, weaken or destroy plastic which may result in serious
personal injury.
electric tools used on fiberglass material, wallboard, spackling compounds, or plaster are subject to
accelerated wear and possible premature failure because the fiberglass chips and groundings are
highly abrasive to bearings, brushes, commutators, etc. Consequently, we do not recommend using
this tool for extended work on these types of materials. However, if you do work with any of these
materials, it is extremely important to clean the tool using compressed air.

LUBRICATION

1. Lower spindle to maximum depth and oil moderately once every three months.
2. Oil the column lightly every two months.
16-Speed Floor Drill Press
Operator's Manual
Do not at any time let brake fluids, gasoline, petroleum-
GFDP160