Genesis GFDP160 Manuel D'utilisation page 6

SPECiFiC SAFETY rULES FOr DriLL PrESSES
WArning:
(gAinED FrOM rEPEATED USE) rEPLACE STriCT ADHErEnCE TO PrODUCT
SAFETY rULES. if you use this tool unsafe or incorrectly, you can suffer serious
personal injury!
• Make sure the drill press is on a firm, level surface and properly
secured
to avoid injury from unexpected movement. Firmly clamp or bolt the drill press to a
support surface to prevent slipping or sliding during the operation.
Unplug the drill press before making adjustments, repairs,
•
maintenance or storing.
• Always switch off the drill press before unplugging it
starting when re-plugging the tool into a power source.
• Use recommended speeds for drill accessories and work piece
material.
• Allow the motor to come up to full speed
stalling.
• Wear eye protection. Do not wear gloves, necktie, or loose
clothing.
• Before starting the operation
other cutting tool does not wobble or cause vibration
• Keep hands away from work area. Keep hands away from the bit.
• Be sure drill bit or cutting tool is securely locked in the chuck.
• Always clamp work piece or brace against column to prevent
rotation.
Never use hand to hold the work piece while drilling.
• Make sure the pulley housing cover is down and the chuck is
installed properly before engaging the power switch.
• Keep bits clean and sharp.
• Lock the switch off when leaving the drill press.
• Before starting, be sure chuck key is removed from the chuck and
the motor head and table are locked.
• Never start the drill press
work piece.
• Adjust the table or depth stop to avoid drilling into the table.
• When using a drill press vise, always fasten the vise to the table.
• Do not operate in rain or in damp locations.
• Grounding required.
SAVE THESE INSTRUCTIONS
16-Speed Floor Drill Press
Operator's Manual
DO nOT LET COMFOrT Or FAMiLiAriTY WiTH PrODUCT
, jog the motor switch to make sure the drill bit or
Sharp bits minimize stalling.
when the bit or other cutting tool is in contact with the
before drilling to avoid binding or
.
GFDP160
to avoid accidental