Publicité
Les langues disponibles
Les langues disponibles
• Use recommended accessories. using accessories and attachments not recommended by the
manufacturer or intended for use on this type tool may cause damage to the tool or result in personal injury to
the user. Consult the operator's manual for recommended accessories.
• Never leave the tool running unattended, turn the power off. Do not leave the tool until it
comes to a complete stop.
• Never start the power tool when any rotating component is in contact with the work
piece.
WarninG:
particles, including wood dust, crystalline silica dust and asbestos. Direct particles
away from face and body. always operate tool in a well-ventilated area and provide for
proper dust removal. Use dust collection system wherever possible. exposure to the
dust may cause serious and permanent respiratory or other injury, including silicosis (a
serious lung disease), cancer, and death. avoid breathing the dust, and avoid prolonged
contact with the dust. allowing dust to get into your mouth or eyes, or lay on your skin
may promote absorption of harmful material. always use properly fitting niOSH/OSHa
approved respiratory protection appropriate for dust exposure, and wash exposed areas
with soap and water.
SERVICE
• Have your power tool serviced by a qualified repair person using only identical replacement
parts. This will ensure that the safety of the power tool is maintained.
• Service your power tool periodically. When cleaning a tool, be careful not to disassemble any portion
of the tool since internal wires may be misplaced or pinched.
eXtenSiOn COrDS
Grounded tools require a three wire extension cord
use either a two or three wire extension cord. As the distance from the power supply outlet increases, you must
use a heavier gauge extension cord. using extension cords with inadequately sized wire causes a serious drop
in voltage, resulting in loss of power and possible tool damage. Refer to the table shown below to determine the
required minimum wire size.
The smaller the gauge number of the wire, the greater the capacity of the cord. For example: a 14-gauge cord
can carry a higher current than a 16-gauge cord. When using more than one extension cord to make up the total
length, be sure each cord contains at least the minimum wire size required. If you are using one extension cord for
more than one tool, add the nameplate amperes and use the sum to determine the required minimum wire size.
Guidelines for Using extension Cords
• If you are using an extension cord outdoors, be sure it is marked with the suffix "W-A" ("W" in Canada) to
indicate that it is acceptable for outdoor use.
• Be sure your extension cord is properly wired and in good electrical condition. Always replace a damaged
extension cord or have it repaired by a qualified person before using it.
• Protect your extension cords from sharp objects, excessive heat, and damp or wet areas.
Recommended Minimum Wire Gauge for Extension Cords (120 Volt)
Nameplate
Extension Cord Length
Amperes
25 Feet
(At Full Load)
0–2.0
18
2.1–3.4
18
3.5–5.0
18
5.1–7.0
18
7.1–12.0
18
12.1–16.0
14
16.1–20.0
12
Compact Heat Gun
Operator's Manual
Use of this tool can generate and disburse dust or other airborne
SAVE THESE INSTRUCTIONS
50 Feet
75 Feet
18
18
18
16
14
12
10
100 Feet
18
18
18
16
16
14
14
12
12
10
10
10
8
8
GHG350
.
Double insulated tools can
150 Feet
200 Feet
16
16
14
14
12
12
12
10
8
8
8
6
6
6
Publicité
