Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
32
3. Disconnect the motor wire harness from the
terminal strip and remove the harness from the
junction box.
EN
Remove the red and white motor wires from the
left side of the 4th and 5th terminals from the top
of the strip.
4. Remove the two screws from the blower
assembly mounting rails located under the
blower division panel near the front of the
appliance.
5. Slide the blower assembly out of the
appliance.
6. Follow the process in reverse to reinstall.
8.13 BLOwEr mOTOr LUBriCATiON
For routine maintenance and improved bearing life, the two motor bearings can be lubricated with non
detergent SAE 20 oil every 12 months.
Do not over lubriCate
W415-1133 / A / 06.12.13
Comme entretien périodique et afi n d'augmenter la durée de vie des roulements à billes, les deux roulements
à billes du moteur peuvent être lubrifi és à tous les 12 mois avec de l'huile non détergente SAE 20.
PLASTIC GROMMET
RED wIRE
NOTE - Most wiring omitted for drawing clarity.
LOwER JUNCTION
BOx wITH COVER
REMOVED - CONTROL
BLOCk TERMINAL
STRIP ExPOSED.
YELLOw wIRE
(JUMPER)
wHITE wIRE
h29.1
Publicité
Chapitres
Table des Matières
Dépannage
