Optional Installation; Blower Kit Installation - Timberwolf Economizer Serie Manuel D'installation Et D'opération

optional installation

6.0 optional installation
EN
6.1

blower kit installation

WARNING
!
• Risk of fire and electrical shock!
• Turn off the gas and electrical power before servicing this appliance.
• Use only Wolf Steel approved optional accessories and replacement parts with this appliance. Using
non-listed accessories (blowers, doors, louvres, trims, gas components, venting components, etc.) could
result in a safety hazard and will void the warranty and certification.
• Ensure that the fan's power cord is not in contact with any surface of the appliance to prevent electrical
shock or fire damage. Do not run the power cord beneath the appliance.
• The wire harness provided in the blower kit is a universal harness. When installed, ensure that any excess
wire is contained, prevent it from making contact with moving or hot objects.
Drywall dust will penetrate into the blower
bearings, causing irreparable damage.
Care must be taken to prevent drywall
dust from coming into contact with the
blower or its compartment. Any damage
resulting from this condition is not covered
by the warranty policy. Use of the blower
increases the output of heat.
Provisions have been made on this
appliance to install an optional blower
kit (EPT70) that comes complete with a
variable speed switch to turn the blower
ON/OFF, as well as adjusting the blower speed.
Ensure the thermal disc bracket is in the correct
A.
position.
Remove the knock-out from the back of the appliance.
B.
Install the blower and housing as shown using the 4
C.
screws supplied.
Loosen the thermal disc bracket (2 screws) and slide
D.
the bracket until the thermal disc is touching the rear of
the firebox and secure.
24
W415-1463 / E / 08.20.18
SPECIFIC BLOWER INSTALLATION
INSTRUCTIONS MUST BE ADDED HERE.
THIS TEMPLATE MUST BE USED WITH ANY
APPLIANCE THAT OFFERS THE BLOWER AS
Check that the thermal
AN OPTION OR COMES STANDARD WITH THE
APPLIANCE... AS PER THE STANDARD.
positioned as illustrated.
THERMAL SWITCH BRACKET
switch bracket is
SCREWS
THERMAL DISC
BRACKET
35.1
2100 PEDESTAL
MODEL ILLUSTRATED