Finishing; Leg Installation - Timberwolf Economizer Serie Manuel D'installation Et D'opération

finishing

5.0 finishing
EN
5.1

leg installation

WARNING
!
• Do not remove knockout unless installing the optional ash drawer kit.
To avoid being damaged during shipping, the appliance has
been bolted to the pallet and must be unbolted before the
appliance can be installed.
note:
If installing the optional ash drawer, see "optional ash
drawer kit (EP20LAD)" section prior to heat shield and
leg installation. Legs may need to be adjusted in order
to properly align with the heat shield holes.
With the bolt through the legs, feed the washer and lock
A.
washer onto the bolt. Thread the nut a thread or two
onto the bolt and slide the leg onto the slot on appliance
as illustrated.
note:
Bolts must be tight prior to heat shield installation.
Slide the heat shield over the four bolts. Finally, secure
B.
the heat shield in place using the remaining nuts.
Lift the appliance up and gently set down on all four legs.
C.
Do not pivot appliance up on its legs, as this could result
in damage to the legs.
For additional logo placement locations, see "OPTIONAL ASH DRAWER"
section.
18
W415-1463 / E / 08.20.18
KNOCKOUT
(SEE WARNING
ABOVE)
KNOCKOUT
(SEE WARNING
ABOVE)
LOGO
PLACEMENT