Finishing; Leg Installation - Timberwolf Economizer Série Manuel D'installation Et D'opération

4.1

leg installation

WARNING
!
• Do not remove knockout unless installing the optional ash drawer kit.
To avoid being damaged during shipping, the appliance has been bolted to the pallet and must be unbolted before
the appliance can be installed.
note:
If installing the optional ash drawer, see "optional ash drawer kit (EP20LAD)" section prior to heat shield and leg
installation. Legs may need to be adjusted in order to properly align with the heat shield holes.
A.
With the bolt through the legs, feed the washer and lock washer onto the bolt. Thread the nut a thread or
two onto the bolt and slide the leg onto the slot on appliance (Fig. 4-1).
B.
Slide the heat shield over the four bolts. Finally, secure the heat shield in place using the remaining nuts
(Fig. 4-2).
note:
Bolts must be tight prior to heat shield installation.
C.
Lift the appliance up and gently set down on all four legs. Do not pivot appliance up on its legs, as this
could result in damage to the legs.
D.
Place logo as illustrated (Fig. 4-3). For additional logo placement locations, see "optional ash drawer"
section.
LOGO
PLACEMENT
Fig. 4-1
KNOCKOUT
(SEE WARNING
ABOVE)
Fig. 4-3
4.0 fi nishing
Fig. 4-2
17
W415-1929 / A / 10.21.19
EN