Ash Drawer Kit (Ep20Lad) - Timberwolf Economizer Série Manuel D'installation Et D'opération

optional installation
EN
5.2

ash drawer kit (EP20LAD)

WARNING
!
• Failure to achieve a good seal between the ash opening and ash plug will result in an over-fi re condition that
could cause damage to the appliance.
Provisions have been made on the appliance to install an optional ash drawer kit. The kit allows for
1. If the appliance has been previously operated, the appliance must
be cold and the ashes must be removed in order to access the
ash plug.
note:
Place the ash drawer from the kit underneath the appliance
to catch falling ashes during the installation.
2. From the underside of the appliance, remove the nuts that
secures the heat shield and the ash opening cover plate.
3. Remove the small light weight brick that is covering the ash
opening, and discard. It is important that the area around the ash
opening be cleaned well to ensure that a proper seal is created
between the new ash plug and the ash opening.
4. Once the area surrounding the opening has been cleaned, place
the new ash plug (supplied) over the opening.
5. Carefully remove the knock out from the heat shield by breaking
the micro tabs.
6. Bend out the four bend tabs at a 90 ° angle from the heat shield.
7. Align the slots in the ash drawer housing with the four bend tabs.
Secure using the four screws supplied.
8. Secure the heat shield and ash drawer housing to the appliance using the nuts removed in step 2.
9. Slide the ash drawer into the ash housing.
24
W415-1929 / A / 10.21.19
convenient removal of excess ash.