Blower Installation - Timberwolf EPI22-1 Manuel D'installation Et D'utilisation

fi nishing
EN
4.6

blower installation

WARNING
!
• Risk of fi re and electrical shock.
• Turn off the electrical power before servicing this appliance.
• Use only Wolf Steel approved optional accessories and replacement parts with this appliance. Using
non-listed accessories (blowers, doors, louvres, trims, etc.) could result in a safety hazard and will void the
warranty and certifi cation.
• Ensure that the blower's power cord is not in contact with any surface of the appliance to prevent
electrical shock or fi re damage. Do not run the power cord beneath the appliance.
Drywall dust will penetrate into the blower bearings, causing irreparable damage. Care must be taken to prevent
drywall dust from coming into contact with the blower or its compartment. Any damage resulting from this
condition is not covered by the warranty policy. Use of the blower increases the output of heat.
This blower is thermally activated. Depending on the intensity of the fi re, the blower will start 15-30 minutes after
lighting. The thermal switch for the appliance is affi xed to an adjustable bracket, which should be positioned so it
is in contact with the blower housing as illustrated.
For shipping purposes the blower housing has
been stored within the fi rebox. We recommend
removing the door prior to installing the blower.
A.
Remove the two screws securing the
cover. Set the screws aside.
B.
Engage the clips onto the retainer
bracket and secure using the screw
supplied.
C.
Re-attach the cover with the two screws
previously removed.
18
W415-2799 / B / 03.10.20
COVER
BLOWER
HOUSING
CLIPS
RETAINER
BRACKET
ADJUSTABLE