Bricks And Baffl Es Installation - Timberwolf EPI22-1 Manuel D'installation Et D'utilisation

fi nishing
EN
4.4 bricks and baffl es installation
WARNING
!
• Operation of the appliance without the baffl es can result in excessive temperatures that could damage the
appliance, chimney, and the surrounding enclosure.
With the appliance and chimney installation completed, move the bricks into place as illustrated below (Fig. 4-4).
A.
Install nine (A) bricks and one (B) brick along the bottom of the fi rebox, working from the back of the
appliance forward.
B.
Install eight (A) bricks along the left and right sides of the appliance.
C.
Install four (A) bricks and one (C) brick along the back wall by pivoting the bricks up under the brick
retainer.
note:
Place brick (C) in the centre, with two (A) bricks on either side as illustrated (Fig. 4-5).
D.
Install two (D) bricks along the front of the appliance below the ledge at the bottom of the door opening.
E.
Carefully pivot two (E) fi bre baffl es up onto the secondary air tubes as illustrated. Ensure that the top
baffl es are pushed all the way to the rear of the fi rebox, leaving a minimum of a 1 inch gap along the front.
This will allow the fl ue gases to escape the fi rebox. Ensure overlap joint is tight.
A
A
A
A
A
D
D
16
W415-2799 / B / 03.10.20
E
E
A
A
C
A
A
A
A
A
A
A
A
B
A
A A
A
Fig. 4-4
BAFFLE
A
A
SECONDARY
AIR TUBES
OVERLAP
JOINT
Fig. 4-5