Bricks And Baffle Installation - Timberwolf 2300 Instructions D'installation Et D'opération

18
5.3

BRICKS AND BAFFLE INSTALLATION

EN
OPERATION OF THE APPLIANCE WITHOUT THE BAFFLES CAN RESULT IN EXCESSIVE
TEMPERATURES THAT COULD DAMAGE THE APPLIANCE, CHIMNEY AND THE SURROUNDING
With appliance and chimney installation completed, move the bricks into place for your appliance as
illustrated.
A. Install the bottom bricks, working from the back of the appliance forward.
B. Before installing the back bricks, loosen the screw holding the brick retainer and ensure that it has
been moved forward. Install the six bricks along the back wall by pivoting the bricks up under the brick
retainer. Retighten the screw.
C. Referring to the appropriate illustration for your appliance, install the fi rst two rows of side bricks
as shown. Pivot fi bre baffl e into place, with the brick retainer down and towards the outside of the
appliance. Slide top row of bricks into place to support the baffl e. Baffl e must sit fl at on outside row of
bricks as well as the fl ange on the manifold shield. Push baffl e all the way to the rear of the fi rebox,
leaving a minimum of a 1" (25mm) gap along the front. This will allow fl ue gases to escape the fi rebox.
D. Install the 4 bricks along the front opening.
NOTE: Do not operate if baffl e and manifold shield are not in position.
W415-1473 / 04.22.15
WARNING
!
ENCLOSURE.
9" x 2" x 19 5/8"
(228.6 x 50.8 x 498.5
mm)
(Fibre Baffles)
W018-0130 X2
Brick
Retainers