Glass Replacement - Timberwolf 2300 Instructions D'installation Et D'opération

26
8.5

GLASS REPLACEMENT

EN
CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS OR
DAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THE
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
A. When the appliance is cool, remove
the door and place it face down on
a soft surface. Be careful not to
scratch the paint.
B. Remove the 5 screws securing the
glass retainers. Remove all broken
glass.
C. Cut the
1
into 3
to glass retainers as illustrated,
ensure the gasket extends past the
ends of the retainers by
D. Apply small beads of silicone in the
gasket groove, as shown.
E. Place the rope gasket in the gasket
groove, on top of the silicone.
F. Place the glass on the door. Re-
install the glass retainers.
W415-1473 / 04.22.15
DO NOT USE SUBSTITUTE MATERIALS.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
APPLIANCE BEFORE OPERATION.
REMOVED, CRACKED, BROKEN OR SCRATCHED.
3 / " (19mm) fl at gasket
4
/ " (89mm) lengths and affi x
2
1
/ " (6mm).
4
WARNING
!
56.2
¾" x 3 ½"
(19.1mm) x (88.9mm)
FLAT GASKET
¼" (6.4mm)
ROPE GLASS GASKET
SILICONE