Door Removal; Glass Replacement - Timberwolf EPI22-1 Manuel D'installation Et D'utilisation

6.5

door removal

WARNING
!
• Burning your appliance with the doors open or ajar creates a fi re hazard that may result in a house and/or
chimney fi re.
• Do not strike or slam door.
• Never remove the door when the appliance is hot.
1. Pivot the door open and lift the door and pins off the bushings.
2. Set the door aside being careful not to scratch the paint.
6.6

glass replacement

WARNING
!
• Do not use substitute materials.
• Glass may be hot. Do not touch glass until cooled.
• Care must be taken when removing and disposing of any broken door glass or damaged components. Be
sure to vacuum up any broken glass from inside appliance before operation.
• Do not strike, slam, or scratch. Do not operate appliance with glass removed, cracked, broken, or scratched.
1. When the appliance is cool, remove the door and
place it face down on a soft surface. Be careful not
to scatch the paint.
2. Remove the 5 screws securing the glass retainers.
Remove all broken glass.
3. Cut the 3/4" (19mm) fl at gasket into 3 1/2" (89mm)
lengths and affi x to glass retainers as illustrated. En-
sure the gasket extends past the ends of the retain-
ers by 1/4" (6mm).
4. Apply small beads of silicone in the gasket grove, as
shown.
5. Place the rope gasket in the gasket groove on top of
the silicone.
6. Place the glass on the door. Re-install the glass
retainers.
note:
For replacement glass, size, thickness, and
specifi cations, see "replacement parts" section.
maintenance
¾" x 3 ½"
FLAT
GASKET
¼" ROPE
GLASS
GASKET
SILICONE
25
W415-2799 / B / 03.10.20
EN