Timberwolf TF 100 Mode D'emploi page 20

20
1. Remove the front lower furnace panel.
2. Remove the lower junction box cover by squeezing sides together and pulling off.
EN
3. Line voltage control circuit wires will enter the appliance through the lower rear knock out on either of the
side panels. Wires must be provided with strain relief where they penetrate the side panel (this must be
accomplished using approved fittings/grommets recognized by the electrical authority having jurisdiction).
4. Once the control wires enter the appliance, they must be ran to the floor panel of the appliance. Then the
wires will be routed and secured along the floor panel to a position directly below the lower junction box.
5. The wires can now be run vertically along side the inside of the rear right corner post until at the height of
the top of the junction box.
6. The wires can then be routed through the plastic grommet located at the top of the lower junction box.
7. The ground wire from the line voltage control circuit will be connected to the ground of the appliance by
connecting it to terminal #1 (top terminal on terminal strip) of the control block terminal strip.
8. Once the yellow jumper wire has been removed from terminals #3 and #4, one power wire from the line
voltage control circuit will be connected to terminal #3 and the other to terminal #4.
9. Replace lower junction box cover.
10. Replace front lower furnace panel.
OPTIONAL WIRING SCHEMATIC FOR EXTERNAL CONTROL OF APPLIANCE BLOWER
OPTIONAL wIRING CONFIGURATION FOR ExTERNAL CONTROL OF APPLIANCE BLOwER
THREE PRONG
W415-1133 / A / 06.12.13
PLUG
VARIABLE
SPEED
CONTROL
M
BLOWER
MOTOR
1
2
3
4
5
GROUND TO WALL BOX CONTAINING
OPTIONAL LINE VOLTAGE
FIELD WIRING BY QUALIFIED
ELECTRITIAN TO REPLACE
JUMPER WIRE BETWEEN
TERMINALS #3 & #4
- FOR CONNECTION TO
ON/OFF SWITCH OR LINE
VOLTAGE THERMOSTAT
BI-METAL
THERMAL
DISK SWITCH
CHASSIS
LINE SWITCH/THERMOSTAT
LINE VOLTAGE SWITCH/
THERMOSTAT