Ayce 5325.1 Traduction De La Notice Originale page 96

5. Always use only a soft, dry cloth to clean your drill; never use any detergent or
alcohol. Disconnect the charger from the mains supply before cleaning.
b. Hole drilling
1. When attempting to drill a large diameter hole, it is sometimes best to start
with a smaller drill bit then work up to the required size. This prevents
overloading the drill.
2. If the drill bit snags, switch off the drill immediately to prevent permanent damage.
Try the reverse drive to remove the bit.
3. Keep the drill in line with the hole. Ideally, if the angle is changed during drilling it
could cause the bit to break, blocking the hole and perhaps causing injury.
4. Frequently remove the drill bit from the hole when drilling deep holes to allow the
dust to be ejected from the hole.
c. Screw driving
1. When driving in larger and/or longer screws in hard material, it is advisable to drill
a pilot hole first, slightly longer and just smaller than the shank diameter of the
screw to be fitted. The pilot hole will act as a guide for the screw and will also make
tightening of the screw less difficult. When screws are positioned close to an edge
of the material, a pilot hole will also help to prevent splitting of the wood.
2. Use only screwdriver bits that fit properly in the head of the screw.
3. When driving screws, always keep enough pressure on the drill to prevent wearing
of the screw head. It will be difficult to drive or remove a screw if the screw head is
worn.
d. Deep discharge protection
This cordless drill is integrated deep discharge protection, when the tool was used
heavily, the discharge protection will operate to cut off inner circuit, after the a few
time rests, discharge protection will reset.