Ayce 5325.1 Traduction De La Notice Originale page 94

b. Torque adjustment (Fig. 4)
Fig. 4
c. Forward/Reverse adjustment (Fig. 5)
Fig. 5
!
Never change the forward/reverse switch while the drill is rotating as
this damage the drill.
WARNING
d. Speed gear box (Fig. 6)
Fig. 6
Select the desired operating torque by
turning the ring to the appropriate setting
and adjust the drilling position
The forward/reverse switch enables you
to change the rotation movement of the
chuck, and also acts as a lock button. For
forward rotation, release trigger switch,
and then depress switch to left handle
side, press switch to right hand side for
reverse rotation, the centre position locks
the drill to off. Always release the trigger
switch when changing rotation. Note the
first time you use the drill after changing
rotation, you may hear a click when the
drill is turned on, and this is normal and
does not indicate a problem.
• Two speed ranges can be pre-
selected with the gear selector.
1. Gear I: Low speed range: for screw
driving or working with large drilling
diameter.
2. Gear II: High speed range: for working
with small drilling diameter.