Ayce 5325.1 Traduction De La Notice Originale page 95

!
NEVER adjust this switch whilst the drill is running. Always let it come
to a complete stop first.
WARNING
e. LED light (Fig. 7)
Fig. 7
f. Fully automatic spindle locking (Auto-lock)
When the trigger switch is not pressed, the drill spindle and thus the tool
holder are locked. This enables screws to be screwed in, even when the
battery is empty and allows for the machine to be used as a screwdriver.
g. Run-on brake
When the trigger switch is released, the chuck brakes to a stop, thus
preventing the run-on of the tool. When driving in screws wait until the screw
is screwed in flush with the material and then release the trigger switch. By
doing so, the head of the screw does not penetrate into the material.
4. Operation for working.
a. General drilling
1. Your cordless drill is useful for drilling holes as well as driving and removing
screws.
2. Use the correct speed for the job; do not try to drill on a slow speed; similarly
do not try to driver screws on a high speed.
3. To prolong the life of your drill never overload it; if it slows down while drilling,
remove and trying again using less force on the drill. If the drill is straining
because the battery pack charge is low, stop and recharge the battery pack.
4. Use slow speed for starting holes without a centre-punch, drilling metals or
plastics, driving screws, and drilling ceramics, or any application requiring
high torque. Use higher speeds for drilling wood and when using polishing
accessories. For maximum drill life use the variable speed control but do not
use it continuously in the variable speed range.
• A LED light source is integrated in the
housing.
• The light is activated as soon as the
On/Off switch is pressed.
GB
94 | 95