Ayce 5325.1 Traduction De La Notice Originale page 81

INTENDED USE
This machine is designed for drilling into wood and metal sheets, and for screwing. Do
not use machine attachments for works other than those for which they are designed
for!
SPECIAL SAFETY INSTRUCTIONS
1. Wear ear protectors. Exposure to noise can cause hearing loss.
2. Hold power tool by insulated gripping surfaces, when performing an operation
where the cutting accessory and fastener may contact hidden wiring. Cutting
accessory and fasteners contacting a "live" wire may make exposed metal
parts of the power tool "live" and could give the operator an electric shock.
3. Hold power tool by insulated gripping surfaces, when performing an operation
where the fastener may contact hidden wiring. Fasteners contacting a "live"
wire may make exposed metal parts of the power tool "live" and could give the
operator an electric shock.
4. If possible, always use clamps or a vice to hold your work.
5. Always switch the toll off, before putting it down.
6. Ensure that the lighting is adequate.
7. Do not put pressure on the tool, such that it slows the motor down. Allow the
bit to screw without pressure. You will get better results and you will be taking
better care of your tool.
8. Keep the area free of tripping hazards.
9. Only use accessory bits in good condition.
10. Before starting, check that there is sufficient clearance for the bit under the
work-piece.
11. Do not touch the bit after operation. It will be very hot.
12. Keep your hands away from under the work-piece.
13. Never use your hands to remove dust, chips or waste close by the bit.
14. Rags, cloths, cord, string and the like should never be left around the work
area.
15. Support the work properly.
16. If you are interrupted when operating the tool, complete the process and
switch off before looking up.
17. Periodically check that all nuts, bolts and other fixings are properly tightened.
18. When using the tool, use safety equipment including safety glasses or shield,
hearing protection, and protective clothing including safety gloves. Wear a
dust mask if the operation creates dust.
19. Even when the tool is used as prescribed it is not possible to eliminate all
GB
80 | 81