Error Codes - JAC SLIM PRO Notice D'utilisation Originale

11 ERROR CODES

Various images (fig.24) are displayed in the event of an error. Each image has an error number.
These numbers are identified in the table below.
Code displayed on screen
1
2
3
4
5
6
7
8
9
Should the problem persist, please contact your technician.
Claw movement error: no movement or no S3
No arm rotation detected (Drive or S4)
No M1 movement detected (upper stepper motor or S8)
S9 sensing problem
SICK sensor error
No M2 movement detected (lower stepper motor or S9)
No communication with MOTOR card
Movement taking too long (program stalled)
SW1 detected after cutting cycle
15
Check
English