Installation; Connection - JVC KD-X320BTS Manuel D'instructions

Wiring connection
Signal cord (not supplied)
JVC Amplifier * 1
Fuse (10 A)
MIC (Microphone
input terminal)
( 14)
Remote wire
(not supplied)
Ignition switch
Car fuse block
Separate red wire
Make this connection if
your vehicle factory wiring
harness does not have
"12 V ignition switch" wire.
* 2
You can also connect a
subwoofer speaker directly
using this lead without an
external subwoofer amplifier.
For setting, 21.
Front output
Rear/subwoofer output
Antenna terminal
To the optional SiriusXM Vehicle Tuner
(commercially available) ( 11)
Light blue/yellow
STEERING
WHEEL
REMOTE
Join the same color wires together.
Blue/white: Remote (200 mA max.)
Orange/white: Illumination
Yellow: Battery 12 V
Red: Ignition 12 V
Black: Ground
Gray: Front speaker (right)
Gray/black
White: Front speaker (left)
White/black
Purple: Rear speaker (right)
Purple/black
2
Green: Rear speaker (left) *
2
Green/black *
* 1
Firmly connect the ground wire of
the amplifier to the car's chassis to
avoid damaging the unit.
Vehicle dashboard
To the steering wheel
remote control adapter
Recommended

connection

Blue: To power antenna
Blue/white: To amplifier
Brown
(Not used)
Part list for

installation

(A) Faceplate
(B) Trim plate
Factory wiring
harness (vehicle)
(C) Mounting sleeve
Vehicle-specific Wiring
Harness (separately
purchased)
(D) Wiring harness
For more information:
(E) Extraction key
Metra Electronics:
www.metraonline.com
Scosche Industries:
www.scosche.com
29
ENGLISH