JVC KD-X320BTS Manuel D'instructions page 28

TROUBLESHOOTING
Symptom Remedy
"CH LOCKED LOCK The selected channel is locked. Enter the correct pass code
CODE?" to unlock. ( 13)
"CHAN UNSUB" The selected channel is unsubscribed.
Call 1-866-635-2349 in U.S.A. or 1-877-438-9677 in Canada
to subscribe.
"CH UNAVAIL" The selected channel is unavailable. Visit
www.siriusxm.com for more information about the
SiriusXM channel lineup.
"CHK ANTENNA" Check the antenna and its connection are in good condition.
"CHECK TUNER" Make sure the SiriusXM Vehicle Tuner is connected to the
unit.
"NO SIGNAL" Make sure the antenna is mounted outside the vehicle.
"SUBSCRIPTION Your subscription is updated. Press the volume knob to
UPDATED – PRESS continue.
ENTER TO CONTINUE."
"CODE ERROR" Make sure you have entered the correct pass code. ( 13)
"NO CONTENT" There is insufficient content to start TuneScan.
"SCAN CANCEL" TuneScan has been aborted.
No Bluetooth device is • Search from the Bluetooth device again.
detected. • Reset the unit. ( 3)
Pairing cannot be • Make sure you have entered the same PIN code to both the
made. unit and Bluetooth device.
• Delete pairing information from both the unit and the
Bluetooth device, then perform pairing again. ( 14)
Echo or noise occurs. • Adjust the microphone unit's position. ( 14)
• Check the [ECHO CANCEL] setting. ( 15)
Phone sound quality • Reduce the distance between the unit and the Bluetooth
is poor. device.
• Move the car to a place where you can get a better signal
reception.
26
Symptom Remedy
Sound is being • Reduce the distance between the unit and the Bluetooth
interrupted or skipped audio player.
during playback of a • Turn off, then turn on the unit and try to connect again.
Bluetooth audio player. • Other Bluetooth devices might be trying to connect to the
unit.
The connected • Check whether the connected Bluetooth audio player
Bluetooth audio player supports Audio/Video Remote Control Profile (AVRCP).
cannot be controlled. (Refer to the instructions of your audio player.)
• Disconnect and connect the Bluetooth player again.
"PAIRING FULL" The number of registered devices has reached its limit.
Retry after deleting an unnecessary device. ( 18,
DELETE PAIR)
"PLEASE WAIT" The unit is preparing to use the Bluetooth function. If the
message does not disappear, turn off and turn on the
unit, then connect the device again.
"BT DEVICE NOT FOUND" The unit failed to search for the registered Bluetooth
devices during [AUTO CNNCT]. Turn on Bluetooth from
your device and connect manually. ( 18)
"NOT SUPPORT" The connected phone does not support Voice Recognition
feature.
"ERROR" Try the operation again. If "ERROR" appears again, check
if the device supports the function you have tried.
"H/W ERROR" Reset the unit and try the operation again. If "H/W
ERROR" appears again, consult your nearest service center.
"BT ERROR PLS UPDATE" Update the Bluetooth firmware. ( 4)
If you have any troubles, try the following:
1 Check TROUBLESHOOTING
2 Reset the unit ( 3)
3 Contact (USA only)
Call: 1-800-252-5722 ( or ) visit: http://www.jvc.com