auna Connect System S Mode D'emploi page 52

EN
52
Software update
1. During System settings mode, press the / buttons to select Software
update and then press the ENTER button to confirm.
2. Press the / buttons to select Auto-check setting or Check now, and
then press the ENTER button toconfirm.
Before downloading software, ensure that the radio is plugged into a stable
mains power connection. Interrupting the mains supply during software
download can lead to functional disturbances and/or damage to the unit!
Setup wizard
The setup wizard is available in the system settings section; you can run
through this to configure settings for date/time and network. Once this has
finished, your radio is ready to use.
Info
1. During System settings mode, press the / buttons to select Info and
then press the ENTER button toconfirm.
2. The software version, Radio ID and Friendly Name will show on the
display.
Info
1. During System settings mode, Press / buttons to select Info and
then press ENTER button to confirm.
2. The software version, Radio ID and Friendly name will show on the
display.
Backlight
1. During System settings mode, press the / buttons to select Backlight
and then press the ENTER button to confirm.
2. For the other settings under Backlight, press the / buttons to select the
following options and then press the ENTER button to confirm.
Operation Mode
Standby Mode
High / Medium/ Low
Timeout off/ 10 sec / 30 sec / 60 sec
Standby Level: High /Medium/Low/Off