Publicité
Les langues disponibles
Les langues disponibles
W 600 WoodPerfect
•
Mount the air hose (Fig. 4, a + b). Insert the air hose firmly into the connection of the
unit and the gun handle. The position of the hose is not relevant.
•
Insert the spray gun into the gun holder on the unit.
•
Put the machine down only on a level, clean surface. Otherwise, the gun may suck in
dust, etc.
•
Sling on the carrying strap with the unit.
•
Remove the spray gun from the gun holder and point it at the object to be coated.
•
It is advisable to test spray cardboard or a similar material in order to determine the
material quantity and the spray pattern.
•
Press the ON/OFF switch at the device.
Three different spray jet settings can be chosen on the spray gun, depending on the
application and target object.
Selecting the Spray Setting
Fig. 5 A = horizontal flat jet
Fig. 5 B = vertical flat jet
Fig. 5 C = circular jet
Adjusting the desired Spray Setting (Fig. 6)
With the union nut (1) slightly unscrewed, turn the air cap (2) to the desired spray-setting
position (arrow). Then tighten the union nut.
WARNING!
Adjusting the Material Volume (Fig. 7)
Set the material volume by turning the regulator on the trigger guard of the spray gun
-
turn to the left
+
turn to the right
Spray Technique
•
The spray result depends heavily on the smoothness and cleanliness of the surface to
be sprayed. Therefore the surface should be carefully prepared and kept free of dust.
•
Cover all surfaces not to be sprayed.
•
Cover screw threads or similar parts of the target object.
•
It is advisable to test the spray gun on cardboard or a similar surface to find the
correct setting.
Important: Begin spraying outside of the target area and avoid interruptions inside
the target area.
for horizontal surfaces
for vertical surfaces
for corners, edges and hard-to-reach
surfaces
Danger of injury!
Never pull the trigger guard while adjusting the air cap.
lower material volume
higher material volume
GB
17
Publicité
