WAGNER WoodPerfect W 600 Traduction Du Mode D'emploi Original page 22

GB
13 Container
Coating Materials Suitable for Use
Finishes, wood sealer-preservatives, staining sealers, oils, clear finishes, water- and
solvent-based paints, primers, 2-component paints
Coating Materials Not Suitable for Use
Wall paints
Alkali and acidic paints.
Coating materials with a flash point below 21°C.
Preparation of the Coating Material
The W 600 can be used to spray paints, varnishes and glazes that are undiluted or slightly
diluted. Detailed information is available in the technical data sheet of the manufacturer
( Internet Download).
1.
Stir the material up and put the required amount into the paint container.
Sprayed material
Glazes
Wood preservatives, mordants, oils, disinfection agents,
plant protective agents
Paints containing solvents and water-soluble paints,
primers, thick-film glazes
2.
If the convey capacity is too low, add 5 - 10 % dilution step-by-step until the convey
capacity fulfils your requirements.
Start­up
Before connecting to the mains supply, be sure that the supply voltage is identical with
the value given on the rating plate.
•
Attach the carrying strap to the unit.
•
Unscrew the container from the spray gun.
•
Aligning suction tube.
If the suction tube is positioned correctly, the container contents can be sprayed
without almost any residue.
When spraying horizontal surfaces, turn suction tube forward. (Fig. 3 A)
When spraying objects overhead, turn suction tube back. (Fig. 3 B)
•
Set the container on a sheet of paper, pour in the prepared coating material and
screw the container tightly onto the spray gun.
16
Description (Fig. 1)
Thinning recommendation
(Fig. 2)
(Fig. 3)
W 600 WoodPerfect
14 Stir stick
undiluted
undiluted
dilute by 5 - 10 %