SOUNDMASTER DAB150 Manuel D'instructions page 11


Full scan
It will pick up the DAB stations available in your area.

Manual tune
This function allows you to check whether a specific frequency can be received in your area
and it's signal strength. When this option is selected, it will show a list of DAB frequencies.
Choose the desired frequency and it will display the signal strength.

DRC
Dynamic Range Control (also known as DRC) can make quieter sounds easier to hear when
your radio is used in a noisy environment.
DRC Off – No compression
DRC High – Maximum compression
DRC Low – Medium compression

Prune
Choose "Yes" on this option, it will delete the DAB stations from your station list that are no
longer valid or stop service.
FM scan
Change to FM mode by pressing the "
the "ENTER" button. It will scan the available stations according to the scan setting selected in
the menu and store to the preset list automatically (see below section for scan setting).
To manual scan, use the "CH-" or "CH+" button and it will fine tune the frequency in a step of
50kHz.
FM main menu
Press and hold the "INFO/MENU" button, it will enter into the menu as follow:

Scan setting
There are two types of scan available. The scan is carried out according to "Strong station"
or "All station". If "Strong station" is selected, it will scan only the channels with strong
reception signal where the radio is placed. If "All station" is selected, it will scan out both the
strong and weak channels.

Audio setting
You can choose to have "Forced Mono" or "Stereo allowed". If the signal is weak and stable
stereo reception is not possible, select "Forced Mono" have better reception.
When a FM station is playing, press the "ENTER" button can access to change the audio
setting. When it appears with "St" it means it's stereo. To select Mono, press "ENTER"
again. The "ST" will disappear and it means Mono is selected.
Preset
To preset a station, press and hold the "PRESET" button, it will enter the list of "Preset Store". If
the preset is available, it will show "Empty". Use the "CH-" or "CH+" button to choose the
preset number and press "ENTER" to confirm. It will display "Preset x stored".
To recall the preset station, simply press the "PRESET" button briefly. Use the "CH-" or "CH+"
button to navigate and press "ENTER" to confirm.
There are 20 presets available for DAB and 20 presets for FM. To save more than 20 stations,
please decide which of the existing one to be replaced with new station.
/MODE" button. To enable Auto Scan, press and hold
3
DAB150 / English Instruction Manual