Various Stages Of The Installation; Mounting The Sauna Heater To The Wall - Helo CAVA DET Manuel Produit

Installation and User Manual HELO CAVA / HELO ROXX DET
3.2.

Various stages of the installation

3.3.1. Mounting the sauna heater to the wall

With the adjustment legs driven in, the mounting height of the sauna
heater wall mount is 750mm from the floor.
The adjustment legs can be adjusted 15mm in case the floor is inclined.
After the mounting, check that both adjustment legs are evenly against
the floor.
The distance between the holes for the mount in the wall is 240mm.
Parts for wall mounting:
- sauna heater locking wedges (A)
- wall fastening (B)
- sheet metal screw 4.2 x 13mm
- build screw 6 x 40mm
Pass the locking wedges (A) through the holes in the heater
so
that the ingoing part is turned upwards.
The wall mount (B) is attached to the wall so that the holes
where the locking wedges are secured to are upwards.
The mount may also be attached directly to the sauna heater.
Mark the locations of the screws on the wall and, if
necessary, drill small holes and mount the sauna
heater then to the wall with the screws provided.
The picture shows how the wall mount should be attached to
the sauna heater. The locking wedges are attached to the
wall mount with the sheet metal screws.
Image 1 Mounting the sauna heater to the wall
An additional foot stand (0043105) is available as an accessory. It will
rise the heater 150 mm from the floor.
The installation instructions are enclosed in the packaging.
Drill diam. o 3,5 mm
2 pcs
1 pc
2 pcs
2 pcs
6
Min.
240 240 mm
2 4 0 m m
A
B