Changing The Handedness Of The Heater; Main Connection - Helo RING WALL STJ Manuel Produit

Product Manual Ring Wall STJ

3.2.2 Changing the handedness of the heater

By default, the thermostat and the timer switch are located
on the left hand side of the heater when viewed from the
front. They can be moved to the other side, if necessary.
The work may only be carried out by a qualified electrician.
1. Turn the heater upside down. Unfasten the bottom plate.
2. Pull the thermostat and timer knobs off.
Remove the two screws in the thermostat and timer body.
Remove the mains connector from the other side.
Remove the plastic caps of the electric housing from the
other side. Move the thermostat and the timer with their
body to the other side, and move the mains connector to
where the thermostat and timer were, secure with the two
screws. Attach the plastic caps to the empty holes.
Push the thermostat and timer knobs on.
NOTE: Leave at least a 1mm gap between the knob and
the outer shell of the heater.
3. Fasten the bottom plate, install the heater and check that it works.

3.3 Main connection

The sauna heater must be connected to the mains by a qualified electrician and in compliance with current regulations. Sau-
na heater is connected with a semi-permanent connection. Use H07RN-F (60245 IEC 66) cables or a corresponding type.
Other output cables (signal lamp, electric heating toggle) must also adhere to these recommendations. Do not use PVC
insulated cable as a connection cable for the sauna heater.
A multipolar (e.g. 7-pole) cable is allowed, if the voltage is the same. In the absence of a separate control current fuse, the
diameter of all cables must be the same, i.e. in accordance with the front fuse.
The connecting box on the sauna wall should be located within the minimum safety clearance specified for the sauna heater.
The maximum height for the connection box is 500mm from the floor.
If the connection box is located at 500mm distance from the heater, the maximum height is 1000mm from the floor. (Image
3 on page 11: Location for the connecting box).
Sauna heater insulation resistance: The sauna heater heating elements may absorb moisture from air, e.g. during storage.
This may cause bleeder currents. The moisture will be gone after a few heating sessions. Do not connect the heater power
supply through a ground fault interrupter.
However, always adhere to the effective electrical safety regulation when installing the sauna heater.
1
4
3
2
1. Thermostat
2. Timer
3. Knobs
4. Overheating limiter reset
5. Mains connector
6. Plastic caps.
10
6
5