Battery Care; Environmental Protection; Repairs - Gesipa AccuBird Mode D'emploi Avec Pièces De Rechange

GB
Charging times
Battery type
1.3 Ah
2.6 Ah
*
Charging times may vary depending on the residual capacity and the battery temperature.
3.4

Battery care

• To obtain an optimum charge, allow the battery to cool down before inserting it in the charger.
• The GESIPA battery can be recharged approx. 1000 times and reaches its full capacity after
®
several charges.
• Do not insert the battery into the charger after each use.
• Only charge the battery when it is discharged and rivets can no longer be set. Only recharge
the battery after a prolonged idle period.
• Significantly shorter battery operating times, despite proper recharging, indicate that the
battery needs to be replaced.
• Store batteries in a dry place where there is no danger of frost. The optimum operating tem-
perature range is 10°C to max. 50°C.
3.5

Environmental protection

If batteries need to be replaced, please observe the following:
• Return used GESIPA
• Never discard used batteries into household waste, fire or into water!
Caution!
In all EU countries (except Germany) the relevant national regulations for implementing
the EU guideline shall apply.
• In accordance with the EU Directive 2002/96/EC (WEEE), in Germany, this tool is
registered under the WEEE Reg.-No. DE 45695505. If the tool has an 8-digit serial num-
ber it can be returned free of charge to GESIPA
4.

Repairs

Repairs under warranty are carried out by the manufacturer. Repairs outside the warranty
period should only be carried out by skilled technical personnel. Failure to observe the
assembly and setting procedures and operation by non-skilled personnel may result in serious
damage to the riveting tool. In case of doubt, always send the riveting tool back to the supplier
or to GESIPA .
®
26
Part No.
143 4921
145 7269
rechargeable batteries to your dealer or to GESIPA
®
Charging time*
approx. 50 min
approx. 100 min.
for correct disposal.
®
for recycling.
®