Siemens SINUMERIK 840D sl Manuel De Mise En Service page 643

[SNMP]
; The following variables define strings which are delivered
; on certain SNMP requests.
; SNMPLocation and SNMPContact are reported for the standard OIDs
; SNMPv2-MIB::sysLocation and SNMPv2-MIB::sysContact, resp.
; SNMPAutLocation and SNMPFunction are used in the Siemens specific
; AUTOMATION-SYSTEM-MIB as automationSystemIdent.automationLocationTag
; and automationSystemIdent.automationFunctionTag, resp.
SNMPLocation="not specified"
SNMPContact="not specified"
SNMPAutLocation="not specified"
SNMPFunction="not specified"
[DCP]
; These variables en/disable the DCP protocol on X120/X127
and X130, resp.
;InternalDcpEnabled=0
;ExternalDcpEnabled=1
[LLDP]
; These variables en/disable the LLDP protocol on X120/X127
and X130, resp.
;InternalLldpEnabled=0
;ExternalLldpEnabled=1
[LinuxBase]
; Keep size of /var/log/messages around this value (not followed
; exactly for performance reasons)
LogfileLimit=102400
; Protocol/Port pairs to open in the firewall
; (e.g., TCP/5900, UDP/514, ...)
;FirewallOpenPorts=TCP/5900 TCP
; If there is only one Ethernet interface, it's used by default as
; an external(company) network. Alternatively, usage as automation
; net (TCU boot support etc.) is possible by setting NetworkModel
; to "automation". (Only NCU, Service and PCU20A variants!)
;NetworkModel=automation
; DisableSubsystems can be used to skip certain CFSes (= subsystems)
; a list of multiple names (separated by spaces) is possible
; a simple name means all CFSes with this name, an absolute path
; (e.g., /siemens/sinumerik/nck) exactly this one CFS
; with the special value "ALL", all subsystems can be disabled
;DisableSubsystems=nck
; Directory for OEM netboot files (served by tftp to diskless clients)
NetbootDirectory=/oem/common/netboot
Système d'exploitation NCU (IM7)
Manuel de mise en service, 03/2010, 6FC5397-1DP10-5DA0
Configuration du système
2.3 Fichier de configuration "basesys.ini"
29