Siemens SINUMERIK 840D sl Manuel De Mise En Service page 642

Masquer les pouces Voir aussi pour SINUMERIK 840D sl:
Table des Matières

Publicité

Configuration du système
2.3 Fichier de configuration "basesys.ini"
; Set synchronization of all DHCP servers in the system/TCU network
; (X120). Possible values are:
; OFF, ON_LOW (low priority),
; ON or ON_HIGH (normal priority), or ON_MASTER (highest priority).
; ON_MASTER is used to make this machine deterministically
; the DHCP master server, but should be used only for one server
; in the network.
;SyncModeDHCPD_SysNet=ON
; This is the range of dynamic IPs given out by the DHCP server
; Defaults should be sensible
InternalDynRangeStart=192.168.214.10
InternalDynRangeEnd=192.168.214.239
; If once a DHCP master was seen, the DHCP server waits this many
; seconds for the master to show up before trying to become the
; active server.
;DHCPDNoMasterWait=120
; DNS domain name used for names in system/TCU network
; (default is "local" to conform with RFC)
InternalDNSDomain=local
; FixedDomain and FixedNameservers can be used to define a DNS
; domain and nameservers, if the DHCP/DNS server on system network
; is disabled.
;FixedDomain=local
;FixedNameservers=192.168.214.1
; If DisableNATRouting is set to 1, the NCU won't forward from TCU
; or IBN net (X120 and X127, resp.) to external net (X130).
; If set to "X120" or "X127", forwarding will only be disabled
; from that interface.
;DisableNATRouting=1
[IBNInterface]
; Setting EnableDHCPD_IBNNet to 0 suppresses that a DHCP server
; is started on that interface.
;EnableDHCPD_IBNNet=0
; If DisableIBNForwarding is set to 1, the NCU won't do NAT routing
; from IBN network (X127) to system network (X120).
;DisableIBNForwarding=1
; If EnableSysNetToIBNForwarding is set to 1, the NCU forwards packets
; from X120 to X127. (Please note that the sending host must be able
; to route the packets to the NCU by its own means, the NCU just
; accepts and forwards packets to 192.168.215.x with this setting.)
;EnableSysNetToIBNForwarding=1
28
Système d'exploitation NCU (IM7)
Manuel de mise en service, 03/2010, 6FC5397-1DP10-5DA0

Publicité

Table des Matières
loading

Table des Matières