Lighting And Adjusting The Open Rings; Lighting And Regulating Gas Oven Burner; Turning On And Adjusting The Static Oven; Turning On And Adjusting The Fan Oven - Lotus cooker PC-94G Instructions Pour L'installation Et L'emploi

LIGHTING AND ADJUSTING THE OPEN RINGS

On the front panel, above each knob, the burner it corresponds to is indicated by the index
Use a lighter to light the gas: turn the knob to the left, from the "0" position to the
(see figure), hold it down and light the gas.
Keep the knob pressed a few second and then let it go, this lights the pilot.
If the flame goes out you have to repeat the procedure.
By turning the knob round to the
By turning the knob round to the
To switch off, move the knob back into position " 0".

LIGHTING AND REGULATING GAS OVEN BURNER

To light, turn the knob to the left from position "0" to the
keep it pushed down and press the button with the
It is possible to check the flame through the inspection hole on the oven floor (bottom); after a
few seconds, release the knob. If the flame goes out, repeat the operation. Turn the knob into
the position of the desired temperature.
To turn off the oven, turn the knob to the right, into position "0"
Attention! - When the oven is on, the door must not remain open because it could heat and
damage the knobs.

TURNING ON AND ADJUSTING THE STATIC OVEN

Turn the control knob to the right and set the temperature wanted.
To turn the oven off, turn the knob to the left to position 0.
To turn the oven on, turn the selector knob (see figure) to the right or left into one of the
following positions
Top + bottom heating element
Bottom heating element
Top heating element
Caution: when the oven is on the door must be kept shut otherwise the knobs and protection
sheet could get hot and be damaged.

TURNING ON AND ADJUSTING THE FAN OVEN

The hot air made to circulate by the fan is distributed in all parts of the oven chamber to
ensure even cooking results. Since the oven chamber is heated evenly, different foods can be
cooked together on different rungs
Turn the knob from "O" into the desired position between 50° and 300°; The white and
green lights come on.
The green light indicates the presence of electrical tension.
The white light shows that the heating element is working; when the temperature is reached,
it goes out. To turn off the appliance, turn the knob into position "O".
NB: Cookers are provided with an acoustic timing device, able to signal a maximum time of
120 minutes. Turn the knob to the right, positioning on the time desired, between and
including 0 to 120 minutes (see figure); at the end of the set time, the alarm goes off.
GB IE
IT CH
position the burner is at maximum
position the burner is at minimum.

MECHANICAL TIMER

46
symbol (see figure);
symbol until the gas lights.
sign