Ignition And Adjustment Of The Cook Top Burner; Ignition Hotplates; Ignition Ceramic-Glass Hotplates; Lighting And Regulating The Gas Oven Burner - Lotus cooker CF4-8ET Instructions Pour L'installation Et L'emploi

IGNITION AND ADJUSTMENT OF THE COOK TOP BURNER

On the front panel, the respective burner is indicated above each knob (the red dot corresponds to
the burner).
To ignite a burner, turn the knob to the left to the
pressed, simultaneously press the button marked
should be pressed for a few seconds and then released. If the flame goes out, repeat the
procedure.
minimum level. To turn it off, turn the knob to the 0 position.
Turn on the main switch placed upstream from the appliance. On the front panel, the respective hotplate is indicated
above each knob .Turn the command knob corresponding to the hotplate from "O" to the desired heating degree
between 1 and 6. White pilot light will turn on as soon as the appliance is live. It is recommended to turn on the
hotplate at maximum and as soon as the temperature has been reached bring the command knob to the desired level. To
turn off the hotplate put the knob back to position "O".
Attention :Never leave the working appliance unattended.
Never use the hotplate without a pan.
Pans must have an even bottom and be of the correct diameter for hotplate (never smaller).
Indications: Each hotplates is provided with a limit switch which cuts off the supply of elettricity when it reaches a
temperature of 450 degrees C.
On the front panel, the respective hotplate is indicated above each knob
Turn the command knob corresponding from "O" to the desired heating degree between 1 and 6. White pilot light will
turn on as soon as the appliance is live. To turn off the hotplate put the knob back to position "O".
The front right and rear left hotplates are made up of a nucleus and a crown.
By turning the knob as indicated above only the nucleus of the hotplate is turned on ;by turning the knob beydon
position "6" the crown is also turned on and you can adjust the temperature from position "1" to position "6" again.
Attention:
Never leave the working appliance unattended!
Keep in mind that during use of the glass-ceramic top the glass surface in the cooking areas increases considerably in
temperature and therefore act acordingly.
It is recommended to use containers with flat bottoms since those with concave or convex bottoms increase the cooking
time and energy consumption.
Indications:
Every hotplate is connected to an energy adjuster which allows you to select among 6 different temperatures. It is
recommended to use the highest temperatures for the first cookings.
-Every hotplate is equipped with a temperature limiting device that intervenes when the temperature reached can
damage the glass.
-When the glass surface is heated the residual heat pilot light turns on, corresponding to the working hotplate. This
indicator will not turn off for as long as the glass keeps a high temperature even with the hotplate off, in order to
prevent the danger of burns.
Warnings:
Do not use pans or any container with aluminium bottoms or coated with tin.
Do not use terracotta pans because they can break or chip and become not so hygienic. It is recommended to use
stainless steel pans with flat, smooth bottoms having a diameter suitable for the heating area. If cast-iron pans are used
make sure not to make them slide on the glass in order to avoid any scoring.
Make sure that the bottom of the pans is thoroughly dry before placing them on the top.
Prevent the glass from getting hit above all by objects with corners and points.
Make sure never to cover the glass with sheets of aluminium paper or similar material, during use.
To light, turn the knob to the left from the "0" position to any one of the positions between
and 250 (see figure); keep the knob pressed until the gas lights.
You can check the flame through the inspection hole on the bottom of the oven; after a few
seconds let got of the knob. If the flame goes out repeat the procedure. Turn the knob round to
the temperature position wanted.
To turn the oven off, turn the knob to the right until it reaches position 0.
Attention: - When the oven is working, the door must not be left open because it can heat
GB
IT
When the knob is turned

IGNITION HOTPLATES

IGNITION CERAMIC-GLASS HOTPLATES

LIGHTING AND REGULATING THE GAS OVEN BURNER

IE
CH
mark (see the figure); while the knob is
until the spark ignites the gas. The knob
to the position, the burner flame is at the
49