Grill Burner; Important; Checking Appliance Operation; Maintenance - Lotus cooker CF4-8ET Instructions Pour L'installation Et L'emploi

until a thermal power of 0.7 kW is reached. This can be done only after operating the oven burner at
Now place the thermostat on position and make
After the adjustment has been made, check
sure that the flame shows no irregularities when quickly passing from maximum to minimum levels and that it
does not go out when the oven door is closed or opened abruptly.
Note: For operation with liquid gas, the minimum flame regulating screw must be thoroughly tightened.
In order to substitute the nozzle, loosen the fixing screws move the burner to the right and unhook it, unscrew the nozzle
with a suitable spanner and substitute it (refer to the Technical Specifications table).
Adjust the air regulating bush to the corresponding value given in the Specifications table by loosening the blocking
screw and the relative nut.
No adjustment to the minimum setting is necessary, as the burner operates with a fixed flame only.

Important!

After transformation to another type of gas, the data plate specifications must also be changed to the type of gas for
which the appliance is now set up.
• Instructions for use are supplied with the appliance.
• Check for any gas leaks.
• Check ignition and verify the burner flame is regular.
• The appliance should always be used according to the instructions supplied.
With prolonged use it is necessary to carry out regular maintenance on the appliance to ensure safe operation. To this
end, a maintenance contract is recommended. The maintenance must be carried out only by skilled technicians who are
familiar with the standards of the country where the appliance is installed, as well as the manufacturer's instructions.
COOK TOP BURNERS: cocks may be replaced by removing the front panel. Sparking plug, thermocouples, burners
may be replaced by removing the grids and basins. In order to substitute the ignition control box remove the middle
dividing panel, which can reached by taking off the the trays.
ELECTRICAL PLATES: Remove the front panel to substitute electrical plates, commutators, pilot lights.
GAS OVEN: Remove the front panel to replace the cock, timer, thermocouples; burners and sparking plugs may be
replaced by removing the bottom plate of the oven.
ELECTRIC OVEN: To substitute the selector, timer, thermostat, pilot lights remove the front panel. Take off the back
panel and from the frontal side inside the oven replace the heating elements, the fan and the spit.
• Disconnect the appliance from the mains.
• Remove the glass casing of the light socket.
• Unscrew the light bulb.
• The new bulb must have the following specifications:
- Heat resistant to 300° C
- 15 W wattage
- 230 V 50 HZ voltage.
Attention! The appliance must only be used under surveillance.
GB
IT
maximum for about 20 minutes (pos. 250 the termostat).

GRILL BURNER

CHECKING APPLIANCE OPERATION

MAINTENANCE

SPARE PARTS

REPLACING THE OVEN LIGHT

INSTRUCTIONS FOR USE

IE
CH
the adjustment.
ignition both at maximum and minimum levels. Make
48