Manual Setup: Video - Yamaha DSP-Z9 Mode D'emploi

Manual setup: Video

Use this menu to adjust the video parameters.
y
If output to the monitor fails while you are performing the
parameter setup procedure, the setting of this unit's video
parameters could be incompatible with your video monitor. Press
and hold down EXIT on the remote control for 5 seconds or
longer to initialize the Video parameters.
Initial settings:
• TV format (TV format):
– U.S.A., Canada, Korea and General models: NTSC
– Other models: PAL
• Resolution (resolution): 480i/576i
• Only TV Format and S Video are avaiable for
progressive or high definition signals (signals with a
resolution of 480p/576p or greater).
• Image processing may not be available for non-
standard signals such as those output by some game
machines.
1
Press TOP on the GUI remote control.
2
Select Manual Setup, then press h.
3
Select Video, then press h.
4
Select the desired parameters, then press h
to access and adjust.
■ Processor (Processor)
Use this feature to turn on/off the digital video processors.
Manual Setup > Video > Processor
Choices: Off, On
• Select Off to turn off the digital video processors.
• Select On to turn on the digital video processors.
* The signal is output without effect processing. (This
setting does not affect the GUI display.)
Notes
• For optimal video performance, THX recommends setting
Processor to Off.
• When playing back video that contains teletext or other
additional signals, the additional signals may not be played
back if you select On. If this happens, select Off.
• When you press TOP on the GUI remote control, the video
processing system is enabled and the GUI screen displayed
even if Off is selected.
SYSTEM OPTIONS
*
71