F6" - Automatic Zero At Start-Up; F7" - Manual Zero Range; F8" - Limitation Of The Tare Functions; F9" - A/D Converter Points - Scale House ASB6 Mode D'emploi Operateur

"F6" - AUTOMATIC ZERO AT START-UP (*)

Trough this step one sets the weight percentage for the automatic acquisition of the gross zero at start-up. If at the start-up
a weight is detected that is within the programmes percentage of the total capacity, it will be cleared; if the weight is not
within this tolerance, the display, after a few instants, shows the current weight.
Press SAVE to select one of the suggested percentages: from 0 to 20.

"F7" - MANUAL ZERO RANGE (*)

Trough this step one sets the weight percentage for the manually acquiring the gross zero; if, in the normal weighing phase,
by pressing ZERO, a weight within the programmed percentage of the total capacity, it will be cleared.
Press SAVE to select one of the suggested percentages: from 0 to 20.

"F8" - LIMITATION OF THE TARE FUNCTIONS (*)

on limitation disabled
oFF limitation enabled
Refers to the 6.3.1 section for the functioning mode.

"F9" - A/D CONVERTER POINTS

By pressing TARE the instrument shows the A/D converter points relative to the weight on the scale.
By pressing ZERO one zero the value.
Press TARE to exit the step.
"F10" - SPEED SETTING ADC CONVERTER READING SPEED
By pressing TARE one sets the reading speed of the ADC converter; the set value corresponds to the number of readings
made in a second.
Press SAVE to select one of the suggested reading speeds: 7.5, 15, 30, 60.

"F11" - BAUD RATE

By pressing TARE one selects the baud rate.
Press SAVE to select one of the possible speeds: 2400, 4800, 9600, 19200.

"F12" - MINIMUM AMOUNT DIVISION

By pressing TARE one selects the minimum amount division.
Press SAVE to select one of the suggested values: 1, 2, 5, 10.

"F13" - PRINTING AND TOTALISATION (*)

on enabled
off disabled

"F14" - PRICE INTRODUCTION MODE

FLoAt introduction with floating decimal point
FiXEd introduction with fixed decimal point

"F15" - PRINTING LANGUAGE AND CURRENCY SYMBOL

By pressing TARE one selects the printing language.
Press SAVE to select one of the suggested values: En, it, ES, Fr, DE.
By confirming with TARE one sets the symbol of the currency to be printed.
Enter the ASCII decimal code of the CURRENCY and press TARE.

"F16" - GRAVITY ZONE OF USE (*)

Through this step one selects the acceleration value of use of the instrument:
Manual entry of the g value: one may manually enter the gravitational acceleration value; one must modify the 6 decimal
11