Cartridge Installation - Geonav 7C Manuel D'emploi Et D'installation

Connections
Network connector (6 pins)
1. Geonav Link network connection
1 I AN GND 1
2 RX +
3 RX -
4 I AN GND 2
5 TX +
6 TX -
English

Cartridge Installation

12
CARTRIDGE INSTALLATION
Installing the CompactFlash™
Open the cartridge slot cover located on the plotter's front
side.
Insert the cartridge into the appropriate slot, with the label
side (side with a small arrow) towards the right, and push it
down.
Close the cover exercising light pressure and check that it is
perfectly closed, in order to avoid any water infiltration.
NOTE: Make sure of inserting the cartridge correctly. Should you try to insert the
wrong side of the cartridge, full insertion into the slot is hampered. Any further attempt
to force the cartridge into the slot may damage the cartridge or the plotter. This kind of
damage is not covered by the warranty.
13
English