Geonav 7C Manuel D'emploi Et D'installation page 20

Quick Tour
The GEONAV is in Navigation
mode; by the joystick, it is pos-
sible to switch to Cursor mode
(editing mode). The cursor posi-
tion is shown by two windows.
The joystick allows moving in all
directions.
To plot a route starting from the
boat's position, move the cursor
to the position desired, and press
ENTER to insert a waypoint, that
will be indicated by a circle con-
taining the number 1.
The windows will also show the
time to reach the target
waypoint, distance, bearing and
estimated time to arrive.
Press the EXIT key to go back to
Navigation mode.
To add more waypoints, enter
the Cursor mode by using the joy-
stick and repeat the operations
described above.
As new waypoints are added,
the numbering will increase pro-
gressively. In case of error,
waypoints can be deleted by
pressing the CLR key (Cursor
mode), starting from the last en-
tered.
To go back to Navigation mode,
press EXIT.
English
36
If an autopilot is connected to the GEONAV, the plotted route
is automatically followed as soon as the Navigation mode is
enabled.
NOTE: The cursor can be moved to the desired position by using the GOTO functions
as well. See the GOTO Section for more details.
The NAVIONICS Gold™ charts provide detailed information
that can be displayed at any time.
By using the joystick, position the cursor on the chart item
desired (symbol for light, buoy, depth area, etc.) and then press
the joystick; the information relative to the items situated in
that given position will be shown.
Use the joystick to scroll the information list, then press EXIT
to exit and select another item.
Press EXIT again to go back to Navigation mode.
37
English