Appliance Set Up; Stove Controls - Osburn OP00030 Manuel D'opération

APPLIANCE SET UP

• Make sure appliance and venting are installed as per manufacturer's instructions;
• Read and follow this operation manual.
• Make sure all tools and accessories has been removed from inside the stove;
3
2
1
Tools and accessories located inside the stove
• Make sure that the burn pot is in place properly and that there is enough pellets in the hopper.
• Plug the telco wire into the touch screen. The wire is attached with a ty-rap on the back of the
stove. Even if the wire looks the same, it is impossible to replace it with a domestic telephone wire.
See parts list in the installation manual or visit our web site for actual part number.

STOVE CONTROLS

The stove, the pellet feeding system and the blowers are controlled by a touch screen, which can be
located at the back, on either side of the appliance or on the wall.
Main page in «OFF» mode
Operation Manual - 3000
No Tools / Accessories
4
1 Humidity absorbant
2 Glove
3 LCD screen
4 Owner's manuals
Main page in «ON» mode
Page 9