Operating Modes; Pilot Mode - Osburn OP00030 Manuel D'opération

Operating Modes

By default, the unit is in thermostat mode (AUTO). To change the operating mode, press the desired
mode in the top menu of the home page.
Main page, operating mode selection
ICON

Pilot Mode

The «Pilot» mode is available in thermostat mode only. It is used to tell the stove what to do when the
thermostat is no longer calling for heat. By default the pilot mode is in «PILOT OFF» mode since it is
the most fuel-efficient configuration.
MODE
The stove will continue to run until the thermostat calls for heat.
Always on
The stove continues to run for 30 or 60 minutes after the thermostat temperature
30 minutes has been reached. If the thermostat does not call for heat before the end of the
60 minutes 30 or 60 minute cycle, the stove will stop and complete a full ignition cycle next
time the thermostat calls for heat.
The stove turns off when the temperature of the thermostat is reached. When
Always off
the thermostat calls for heat, the stove will complete a full ignition cycle .
The pilot heat level is less than the minimum heat level in the normal combustion mode.
Page 14
Operating mode
(Thermostatic or
manual)
Indicates that the stove is in manual mode. It will run continuously at the
selected heat level until it is manually changed or turned off.
Indicates that the stove is in thermostat mode. The red waves indicate
that the thermostat calls for heat. The stove will operate at the selected
heating level until the thermostat reaches the required temperature.
When the thermostat has reached the required temperature, the red waves
will disappear and the selected pilot mode will start. When the thermostat
is calling for heat again, the icon will change to the one with waves and
a new combustion cycle will start with the parameters of the last setting.
DESCRIPTION
DESCRIPTION
Operation Manual - 3000