The Appliance Overheats; Hopper Lid Open; Power Loss - Osburn OP00030 Manuel D'opération

The exhauts temperature sensor is faulty. When the stove is cold, the temperature displayed on page
1 of the «TROUBLESHOOTING» menu should show the ambient temperature of the room where
the appliance is installed. If this is the case, put the stove on. After 10 minutes, if the value has not
increased, the exhaust temperature sensor is disconnected or defective.

The Appliance Overheats

The main cause of a stove overheating is lack of maintenance. Any overheating code should be
followed by thorough maintenance of the unit and a venting system inspection.
The overheating code may also appear if the burn pot or the baffle is not installed correctly, or if the
convection fan is defective.
After three repetitions of an overheating code, it will not be possible to restart the stove.
When the appliance and the venting system maintenance is complete, unlock the screen by entering
the code 999333555. Press «ACCEPT».

Hopper Lid Open

The hopper lid remained open for more than 3 minutes. As a safety measure, the rotary valve stops
feeding pellets as soon as the hopper lid opens. It will resume normal operation as soon as the lid is
closed. If the lid remains open for more than 3 minutes, the stove stops.
The hopper lid switch is faulty or improperly connected. Test the switch. See «Checking the Status and
Testing a Component» section. If the switch does not work, it may be faulty or improperly connected.

Power Loss

The current was interrupted during operation. After the cooling cycle, the stove restarts using the last
settings. For short-term power failure (less than 5 seconds), the stove will continue to operate at the
selected speed.
Operation Manual - 3000
Before unlocking the stove, do the biannual
maintenance suggested
schedule. Carefully inspect the venting system.
Have it swept, if necessary.
in the maintenance
Page 35