Verifying The Door Seal; Adjusting The Door - Osburn OP00030 Manuel D'opération

Verifying the Door Seal

Test the door seal by closing and latching the door on a strip of paper. Test all around the door. The
paper should not slip out easily. If it does, see the «adjusting the door» section.
Door sealing test

Adjusting the Door

In order to achieve optimal performance, the door must be completely sealed with the combustion
chamber. The gasket must therefore be inspected periodically in order to obtain an airtight fit. The
sealing can be improved with a simple adjustment of the latch mechanism.
Remove the retaining pin by pulling and turning with a pair of pliers. Turn the handle one turn
counterclockwise to increase the pressure between the door frame and the stove structure. Reinstall
the retaining pin using a hammer.
Removing the retaining pin
Page 30
Reinstalling the retaining pin
Operation Manual - 3000