Stove Operation; First Startup / Beginning Of Season; Every Day Startup; Running Out Of Pellets - Osburn OP00030 Manuel D'opération

STOVE OPERATION

First Startup / Beginning of Season

Before starting the stove, the burn pot, both parts of the baffle and the access panels must be
installed correctly. The stove and hopper must have been emptied of all tools and accessories (see
«Before operating the stove»). In addition, all doors and covers must be closed and the vent system
properly installed and sealed.
Fill the hopper and press the start icon on the home page. The color of the start button will alternate
from green to yellow during the startup period. When the stove is turned on, it will automatically ignite.
No fire starter is required.
If the stove does not light within 20 minutes of starting, the message «FAILED IGNITION» will appear.
See the troubleshooting section for details.
During the first few fires, the stove will emit an odor and a small amount of fumes as the high temperature paint
cures or becomes seasoned to the metal. Maintaining smaller fires will minimize this. Avoid placing items on
stovetop during this period to avoid damaging the paint surface. Make sure the room is well-ventilated. Open
windows. Odors and fumes released during this process are unpleasant but they are not toxic.
Make two or three low intensity fires to initiate the hardening and conditioning process. Then,
make high intensity fires until the stove no longer smells like paint.
NEVER USE A GRATE OR OTHER MEANS TO SUPPORT THE FUEL. USE ONLY
THE APPROVED BURN POT FOR THIS STOVE AND DO NOT MODIFY IT.

Every Day Startup

Before startup, make sure that the recommended maintenance has been performed according to the
schedule (see «Maintenance» section). Fill the hopper and press the start icon on the home page.

Running Out of Pellets

If the stove runs out of pellets, the fire will slowly go out. The convection blower will remain on until
the heat sensor reads 115 °F. The cooling cycle will take a few minutes before all other motors stop.
When this temperature is reached, the message «NO FUEL» will appear.
Restarting the stove will only be possible when all blowers
are off (about 10 minutes after the error message appears).
Press «RESET», fill the hopper and press the start icon on
the home page.
Page 18
Screen « No fuel »
Operation Manual - 3000