Troubleshooting; Validating Status And Testing A Component; Electronic Components - Osburn OP00030 Manuel D'opération

TROUBLESHOOTING

Most common problems are generally caused by one or more of the following factors:
1. Wrong operation or lack of maintenance;
2. Bad installation;
3. Poor fuel quality;
4. Component failure;
The stove is equipped with a PC board which informs the user when a problem occurs. It is therefore
important not to unplug the stove when it is in operation, as it will be impossible to see the message
and correct the problem. In addition, unplugging the stove will disable all the safety functions.
In order to obtain a fast and personalized service, the manufacturer's model number and serial number must
be provided when contacting the retailer or manufacturer. (This information can be found on the certification
label inside the hopper lid).

Validating Status and Testing a Component

Electronic Components

At any time during the operation of the stove, it is possible to see the status of each of the following
components:
• F-160 (heat sensor)
• L-250 (heat sensor)
• Pressure sensor
Press the configuration button on the main page then press on the «TROUBLESHOOT» menu.
Page 32
• Hopper switch
• RTD (Temperature probe)
• Thermostat (Temperature regulator device)
DEMO
Access to the troubleshoot menu
Operation Manual - 3000