Installation And Connection - Bartscher AT90 Mode D'emploi

•
Do not use any accessory or spare parts that have not been recommended by the
manufacturer. These can be dangerous for the user or lead to damages of the
device or personal injury, and further, the warranty expires.
•
Do not move or tilt the device when in operation.
•
Never use the device with wet or moist hands.
•
Never leave the device unattended when in use.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!

5.2 Installation and connection

ATTENTION!
Any installation, maintenance and repair work should be executed only by an
authorized installation engineer!
•
Unpack the device and dispose adequately all packaging material.
•
Mount the adjustable feet to the device and set the desired height by screwing the
feets in or out. Do not use the device without installing the adjustable feet.
•
Remove carefully the protective film from the outside walls so as to avoid adhesive
residues be left. If any adhesive residues remain, remove them with a suitable
solvent.
•
Place the device on a flat, safe surface which can withstand the weight of the device
and is not heat sensitive.
•
Never place the device on an inflammable surface.
•
Do not place the device near open fireplaces, electric ovens, heating stoves or other
heat sources.
•
Place the device so that the rear ventilation holes were not blocked or covered.
•
Do not place the device near walls or other objects made of combustible materials.
Keep a minimum distance of 10 cm on all sides.
•
Do not place any objects on the device.
- 27 -