Safety Warnings; Product Description - Fracarro SIG7100 Instructions D'emploi

The product must be installed only by qualified persons, according to the local safety standards and regulations.
It is classified as Class II, in accordance with EN 60065 and, for this reason, it shall not be connected to the
protective earth (PE) of the supply mains. The product must be installed in an Headline Sub-rack and it must not
be connected directly with an external power cable.
Installation warnings
• The product must not be exposed to dripping or splashing and thus it shall be installed indoors, in a dry
place.
• Humidity and condensation could damage the product. In case of condensation, wait until the product is dry
before using it.
• Don't install the product above or close to heat sources, in dusty places or where it might come into contact
with corrosive substances.
• Leave enough space around the product housing to ensure sufficient ventilation; an excessive operating
temperature and/or an excessive heating may affect the performance and the life of the product.
• To prevent injury, this product must be securely connected to a Sub-rack, in accordance with the mounting
instructions, given in Chapter 3.
In accordance with the European Directive 004/108/EC (EMC), the product shall be installed using devices,
cables and connectors that allow to comply with this directive requirements for fixed installations.
Fracarro Radioindustrie SpA is not responsible for the possible network diffusion of the television signal de-
coded by SIG7100. The installer and the product user must follow the user conditions provided by the service
provider and those specified in the purchasing agreement of the "smart card".
Therefore, Fracarro Radioindustrie SpA is relieved from any civil or criminal responsibilities due to a breach of
juridical regulations in the matter and arising from any improper use performed by the installer, by the user or by
third parties.
Earthing of the antenna system
The Sub-rack, where the unit will be installed, must be connected, directly or through the rack, to the earth
electrode of the antenna system, in accordance with standard EN 50083-1, section 10.It is recommended to
follow the provisions of EN 50083-1 and not to connect the Sub-rack or the rack to the protective earth (PE) of
the supply mains.
IMPORTANT: Never remove the product cover, parts at hazardous voltage could be accessible when the prod-
uct case is opened. Only instructed and authorized persons can open the product. In case of failure, do not try
to repair the product; otherwise the guarantee will no longer be valid.
The module SIG7100, thanks to the slot Common interface, receives a free-to-air or a coded digital signal from
a satellite antenna in DVB-S or DVB-S standard. It makes the audio/video signal available on the RCA output
connectors (only for program MPEG- compressed) and also in the Transport Stream distributed on the back-
panel of the headend.
So it can be installed stand-alone to
distribute only one program through
the RCA outputs or it can be connected
to the module SIG710 (COFDM
modulator) that, using Transport-
Stream flow, allow to distribute also
channel MPEG-4 compressed.
Every single module can generate
14/18V, a KHz tone and a DiSEqC 1.0
tone-burst to control multiswitches, if
any, or LNB (max 00mA@14V remote
power feed).
The device is equipped as follow:
• 1 input F connector (SAT IN) to connect SAT signal from LNB converter;
• 1 SAT loop-through RF connector (SAT OUT);
•  operation and signal LEDs (see the summarizing table);

1. SAFETY WARNINGS

2. PRODUCT DESCRIPTION

SAT INPUT
RIGHT AUDIO OUTPUT
LEFT AUDIO OUTPUT
VIDEO OUTPUT
15
OUTPUT TO OTHER
MODULES
CAM INPUT