Fracarro SIG7100 Instructions D'emploi page 21

5.3.3 HEADEND SETUP AND KTP EMULATION MENU
Navigation in the
headend programming
HEADEND
SETUP
On Screen Display settings
visualization
Automatic
acknowledgement of
the headend connected
to the TPE
Export the headend
configuration to another one
Restore the module
defaults setting
Restart the module
Emulation of the KTP
KTP
EMULATION
NOTE: It is possible to modify the address only for the interconnection module SIG7900; after the modify it is
necessary to scan the headend to update the addresses of all module in the rack, otherwise disconnect and re-
connect the TPE from the headend to do the automatic scanning.
SIG7100
Setting the output parameters
Measurements of the input and
menus
NAVIGATION
NAVIGATION OSD
HEADEND SCAN
COPY
FACTORY SETUP
SET ADDRESS
RESET MODULE
programmer
KTP
EMULATION
Confirm the settings by pressing the
pressing the S key after the modules programmation.
5.3.4 SIG7100 GENERAL MENU
Setting the input parameters
INPUT
OUTPUT
MEASURE
output signal
COMMON INTERFACE
COMMON INTEFACE
Settings menù
Confirm the settings by pressing the
pressing the S key after the modules programmation.
Refer to the SIG7100 general
SIG7100 programming menu
Automatic s earch of the
headend or the connected
device. After searching, the
Search module....
main menu can be seen
from the NAVIGATION
function
All
SIG7100
modules
Read-only
Address not Address not v alid v alid
All
SIG7100
modules
The function is not
available for the
V=OUTPUT
programming of the
SIG7100 module
key; save the settings by
INPUT MENU
22
see page
OUTPUT MENU
24
see page
MEASURE MENU
25
see page
COMMON INTERFACE MENU
25
see page
key; save the settings by
1
Yes=V NO=X
Yes=V NO=X